Note: If the ! error light turns on, the connection failed. When the ready and Wi-Fi lights on the scanner stay on, the scanner is connected to the network. Press the power button to turn on the scanner.Note: If you do not enter the code within 2 minutes, repeat steps 1 through 6. The ready and Wi-Fi lights on the scanner stay on, indicating that the scanner is connected to the network. Use your computer to enter the PIN code 01234565 into the WPS PIN number setting in the wireless router within two minutes.
Note: The scanner enters WPS discovery mode for 2 minutes. Release the Wi-Fi connect button when the ready and Wi-Fi lights flash alternately.
Press and hold the Wi-Fi connect button as you press the power button to turn on the scanner. Set the connection mode switch on the side of the scanner to the AP mode position. Slide the cover latch to open the scanner. Find the WPS PIN number setting in your router's firmware. Make sure you have installed your scanner software as described on your scanner Start Here sheet. Using WPS PIN Mode to Connect to a NetworkIf you have a WPS-enabled wireless router that supports PIN mode, you can use Wi-Fi Protected Setup (WPS) PIN mode to connect your scanner to the network (ES-300W/ES-300WR). You must set up network scanning to connect your computer and wireless scanner. Select the link below to set up network scanning. Press the stop button to clear the error, restart the scanner and router, and repeat these steps. 
Note: If you do not complete this step within 2 minutes, repeat steps to try again.When the ready and Wi-Fi lights on the scanner stay on, the scanner is connected to the network.
Press and hold the Wi-Fi connect button on the scanner for at least 3 seconds, then release it when the ready and Wi-Fi lights flash alternately. Note: If you cannot locate the WPS button, or there are no buttons on the router, see the documentation provided with your router for details. The router enters WPS discovery mode for 2 minutes. Enable WPS on your router by pressing and holding the WPS button until the security light flashes or by enabling the WPS setting in your router firmware. Set the connection mode switch on the scanner to the Wi-Fi position. 
Note: For best results, re-install your scanner software and follow the on-screen instructions to connect to a network. Using WPS to Connect to a NetworkIf you have a WPS-enabled wireless router, you can use Wi-Fi Protected Setup (WPS) to connect your scanner to the network (ES-300W/ES-300WR). How do I connect my WPS-enabled wireless router to my product?
0 kommentar(er)
